A perfect pack for insulating your car from engine noise and heat, while protecting the paint job also! When you order an upgraded comfort package from the dealer, they will add insulation to the underside of the hood. Now, you can enjoy an even better insulating experience using our Hood Kit! by installing this product on the underside of your hood, you can reduce the engine noise and heat that travel through the hood and through the front cowling under the windshield!Includes all the Products and tools required for application on an average hood:
Noise Reduction Uses...
When installed on the hood, this package takes care of the vibrations that travel up from the engine, through the hood, and through the plastic cowling at the base of the windshield, making your sound system easier to hear and your ride that much more comfortable!
When installed on the hood of your car, this package helps absorb the heat that radiates off of your engine, through your hood, and through the cowling at the base of your windshield as well as the windshield itself! With this heat source out of your car, you will get a much greater effect out of your air conditioner, making those hot summer drives much more comfortable!
NOTE: SPRAY ADHESIVE CANNOT BE SHIPPED INTERNATIONALLY.
Hood Application Pictures:
Step 1 - Clean the metal with denatured alcohol to start with a fresh clean surface.
Step 2 - Test fit and cut your sheets of Damplifier Pro to your specific hood shapes. Apply the Damplifier Pro vibration dampening sheets by pushing the product on and then rolling it tight with a wooden roller.
Step 3 - Test fit the full sheet of Heat Wave Pro to see how much you will need to cut off to cover your specific hood. It is best to cut the Heat Wave Pro with scissors. Once fitted, get extra hands to help you apply it. Spray both the Heat Wave Pro and the top of the Damplifier Pro with the high temp spray adhesive. Wait about 90-120 seconds for glue to tack up. Once glue is tacky, push the Heat Wave Pro onto the hood area, start from the middle and push it on towards the outer edges last. Hold product in place for a few minutes to make sure glue is full bonded before letting go. It is recommended to tape the edges (and any seams you may have had to create) with the included foil tape . Physical fasteners are recommended to install Heat Wave Pro to the hood.